Keywords
passive cooling
tropical climates
CFD modeling
Abstract
Photovoltaic (PV) module performance is significantly constrained by operating temperature rise, particularly in hot and tropical climates where a large portion of incident solar radiation is converted into heat rather than electricity. Experimental and review studies report that PV module temperatures commonly reach 50–60 °C and may approach 80 °C under high ambient conditions, resulting in a power reduction of approximately 0.4–0.5% per °C increase above standard test conditions. This performance degradation is primarily due to temperature-induced reduction in open-circuit voltage and is further associated with accelerated material aging and reliability losses. To address thermal losses, research has increasingly focused on passive and low-energy cooling strategies. These include rear-mounted heat sinks and fins that enhance natural convection, air channels and chimney-based designs that promote buoyancy-driven airflow, and phase change material (PCM) systems that absorb excess heat through latent thermal storage. Recent studies emphasize thermal conductivity enhancement of PCM using fins, metal foams, or structured containers, achieving PV temperature reductions exceeding 20 °C and corresponding efficiency improvements. Water-assisted backside cooling and hybrid systems combining air, conduction, and water mechanisms have also demonstrated short-term gains in electrical output under high solar irradiance. Despite notable progress, key research gaps persist, including the absence of standardized net-energy evaluation frameworks, limited long-term field data linking cooling to degradation reduction, challenges in PCM discharge under hot night conditions, water sustainability concerns, and insufficient emphasis on scalable, low-cost, and retrofit-compatible designs. Addressing these gaps is critical for reliable PV operation in high-temperature environments.
References
1. Ahmad, E. Z., Sopian, K., Jarimi, H., Fazlizan, A., Elbreki, A., Abd Hamid, A. S., Rostami, S., & Ibrahim, A. (2021). Recent advances in passive cooling methods for photovoltaic performance enhancement. International Journal of Electrical and Computer Engineering, 11(1), 146–154.
2. Ahmed, Y. E., Pasupuleti, J., Alhousni, F. K., & others. (2025). Designing integrated intelligent control systems for photovoltaic cooling and dust panels based on IoT: Kirkuk study, Iraq. Renewable Energy Systems Journal.
3. Al-Azawiey, S. S., Mohamed, M. M., & Arifin, A. B. (2023). Effectiveness of PV/T passive natural air cooling by backside attached fins. Energy Reports.
4. Almukhtar, H., Lie, T. T., Al-Shohani, W. A. M., Anderson, T., & Al-Tameemi, Z. (2023). Comprehensive review of dust properties and their influence on photovoltaic systems: Electrical, optical, thermal models and experimentation techniques. Energies, 16(8), 3401.
5. Apribowo, C. H. B., Tjahjana, D. D. P., Trisnoaji, Y., & others. (2025). Mathematical modeling and optimization of photovoltaic–phase change material cooling systems for enhanced thermal management in public electric vehicle charging stations. Journal Européen des Systèmes Automatisés, 58(9), 1861–1878.
6. Arifin, Z., Prasetyo, S. D., Rachmanto, R. A., & others. (2023). Optimizing photovoltaic thermal collector temperature with varying number of collectors: A CFD simulation study. Applied Thermal Engineering.
7. Atia, D. M., Hassan, A. A., El-Madany, H. T., & others. (2023). Degradation and energy performance evaluation of mono-crystalline photovoltaic modules in Egypt. Energy Reports.
8. Badi, N., & Laatar, A. H. (2024). Improved cooling of photovoltaic panels by natural convection flow in a channel with adiabatic extensions. International Journal of Thermal Sciences.
9. Barbu, I.-M. (2021). Étude et optimisation des capteurs solaires photovoltaïques thermiques hybrides et de leur intégration dans des systèmes énergétiques de petite taille destinés aux prosommateurs (Doctoral dissertation).
10. Bayrak, F., Oztop, H. F., & Selimefendigil, F. (2020). Experimental study for the application of different cooling techniques in photovoltaic (PV) panels. Energy Conversion and Management, 212, 112789.
11. Bijjargi, Y. S., Kale, S. S., & Shaikh, K. A. (2016). Cooling techniques for photovoltaic module for improving its conversion efficiency: A review. International Journal of Mechanical Engineering and Technology, 7(4), 22–28.
12. Cabrera-Escobar, R., Cabrera-Escobar, J., Vera, D., Jurado, F., Orozco-Cantos, L., Córdova-Suárez, M., & García-Mora, F. (2024). Comparative analysis of material efficiency and the impact of perforations on heat sinks for monocrystalline photovoltaic panel cooling. Energies, 17(21), 5511.
13. Elkhoundafi, O., & Elgouri, R. (2025). Development and testing of a dedicated cooling system for photovoltaic panels. International Journal of Electrical and Computer Engineering, 15(5), 4387–4394.
14. Enasel, E., Lupu, A.-G., & Dumitrașcu, G. (2023). Design and development of cooling systems for PV cells performance improvement. Energies, 16(12), 4567.
15. Fahad, A. S., Osman, K., Abidin, U., Ahmad, M. S., Ismaeil, E. M. H., & Farooq, M. U. (2025). Review of cooling techniques for improving solar photovoltaic panel efficiency. Journal of Advanced Research in Fluid Mechanics and Thermal Sciences, 125(1), 193–219.
16. Faisal, F., Rashel, M. R., Tlemçani, M., & Ahmed, M. T. (2023). A comparative review on cooling techniques to develop hybrid PV/T panel. IEEE Conference Proceedings.
17. Fuentes-Hernández, D., Vargas Ramírez, M., Legorreta García, F., & others. (2024). Computational simulation in solar energy: Effect of passive cooling in the generation of photovoltaic cells in Pachuca de Soto, Mexico. Sustainable Energy Technologies and Assessments.
18. Glick, A., Ali, N., Bossuyt, J., & others. (2020). Utility-scale solar PV performance enhancements through system-level modifications. Progress in Photovoltaics: Research and Applications, 28(6), 497–512.
19. Glick, A., Smith, S. E., Ali, N., & others. (2020). Influence of flow direction and turbulence intensity on heat transfer of utility-scale photovoltaic solar farms. Solar Energy, 206, 627–639.
20. Hamad, A. J., Hussein, F. M., & Tarish, A. L. (2023). Evaluating the effects of air cooling on photovoltaic module performance in hot climates: A comprehensive numerical and experimental investigation. Energy Conversion and Management.
21. Hamdan, M., Abdelhafez, E., Al-Aboushi, A., Othman, A., Al-Saleh, S., & Ajib, S. (2023). Enhancing PV modules performance using L-shaped aluminum fins. International Review of Mechanical Engineering, 17(2), 48–56.
22. Harmailil, I. O., Sultan, S. M., Tso, C. P., Fudholi, A., Mohammad, M., & Ibrahim, A. (2024). The state of the art of photovoltaic module cooling techniques and performance assessment methods. Symmetry, 16(4), 412.
23. Hussien, A., Eltayesh, A., & El-Batsh, H. M. (2022). Experimental and numerical investigation for PV cooling by forced convection. Energy Reports.
24. Karthikeyan, M., & Johnson, J. (2020). Analysis and performance improvements of photovoltaic system using fins for heat reduction by CFD. International Journal of Engineering Research and Technology.
25. Kumar, R. S., Priyadharshini, N., & Natarajan, E. (2015). Experimental and computational fluid dynamics study of glazed three-dimensional PV/T solar panel with air cooling. Energy Conversion and Management, 103, 907–917.
26. Lau, S.-K., Zhao, Y., & Shabunko, V. (2018). Optimization and evaluation of naturally ventilated BIPV façade design. Energy and Buildings, 164, 281–295.
27. Majumder, A., Kumar, A., Innamorati, R., Mastino, C. C., Cappellini, G., Baccoli, R., & Gatto, G. (2023). Cooling methods for standard and floating PV panels. Energies, 16(24), 7939.
28. Pomares-Hernández, C., Zuluaga-García, E. A., Escorcia-Salas, G. E., Robles-Algarín, C., & Sierra Ortega, J. (2021). Computational modeling of passive and active cooling methods to improve PV panels’ efficiency. Applied Sciences, 11(23), 11370.
29. Wang, Y., Xiao, C., & Bedon, C. (2024). Performance of photovoltaic panels with different inclinations under uniform thermal loading. Solar Energy, 262, 112–123.
30. Zhang, G., Misaran, M. S., Zhang, Z., Radzali, M. A., & Ismail, M. A. (2024). Solar photovoltaic surface cooling using hybrid solar chimney-collector with wavy fins. Journal of Advanced Research in Numerical Heat Transfer, 22(1), 46–58.
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
Copyright (c) 2026 Author